Setting the Options Also, in the previous figure, note the Lower/Upper Warning Limits (indicated by the yellow vertical bars), and the Lower/Upper Error Limits (indicated by the red vertical bars). Setting the Options The Options dialog allows you to enable data logging and to set the graph duration and refresh period. To access the Options dialog, from the System Monitor tool menu, select Control > Options . The Options dia- log opens, as shown in the following figure. Options Dialog The options are described in the following table. ACE User's Guide, 3.6.x 18316-000 Rev A Page 1124 Item Description Logging Enabled When checked, data logging is enabled.
The captured data is written to a file located in the specified Log Folder. Logging creates a .CSV file with all the data plus a time stamp. The size of this file is limited to 10 MB. When the 10 MB limit is reached, the file is renamed and a new file is started. When the new file reaches 10 MB, the first file is deleted, the second file is renamed, and a new file is started. Only two files are kept at the same time. Log Folder Specifies the folder where the log file will be stored. Graph Duration Specifies the graph duration. The range is from 1 minute to 1 week. For