Arc Edge Locator edge location settings. 3. Refer to sections below for help on configuring edge settings, and using the display and function editor. The Edge Settings Window NOTE : If the display in the Edge Settings window is blank, or the edges are not properly placed, close the window and verify that the correct Projection Mode is enabled in the Advanced Parameters section. Choose between Annular and Radial. Also verify that the tool was executed after positioning the tool. Execute the tool at least once before opening the Edge Settings window.
Edge Detection Edge Detection settings configure the parameters that the Arc Edge Locator will use to find potential edges in the region of interest. The display represents the Arc Edge Locator region of interest and provides information to assist in configuring Edge Detection parameters. ACEUser's Guide, 3.6.x, 18316-000 Rev A Page 376