omron — Viewing Belt Encoders and Testing Latches

Viewing Belt Encoders and Testing Latches Belt Encoders 2. Select a belt encoder from the list. 3. Activate the belt and watch the Encoder Position and Scaled Position values. These values should change when the belt moves. If the belt is under active control by the Adept controller, you can use the wizard belt controls to activate the belt. For details, see Wizards on page 181. 4. When finished, click Next to close the wizard. Testing Latch Signals To test the latch signal inputs for the selected belt: ACE User's Guide, 3.6.x, 18316-000 Rev A Page 819