Maintenance 5 Welding instructions Turn off the engine start switch (OFF position). Disconnect the negative terminal on the battery. Do not apply more than 200V continuously. Connect grounding cable within 1 m from the area to be welded. No seals or bearings may be between the area to be welded and the grounding point. Never weld any pipe or tube containing fuel or oil. Keep a safety distance of min. 1 m between the area to be welded and the battery. Fire prevention Use nonflammable cleaners or light oil for cleaning parts. Keep flame or cigarette light away from light oil.
Clamp faces When O rings or gaskets are removed, clean the clamp faces and replace the O rings and gaskets with new ones. Be sure to fit O rings and gaskets during re-assembly! Objects in your pockets Keep your pockets free of loose objects which can fall out and drop into the machine (especially when bending over the machine). Tyres check When working in rocky areas, check the tyres for damage and for looseness, flaws, wear and tear. Re-tighten loose bolts and nuts. Precautions when washing the machine Place the machine on a plane, even surface. Lower the work equipment to the ground. Apply the parking brake. Lock the wheels using support wedges to prevent the machine from rolling away.
Proceed the following general measures, if you want to clean the machine: Never spray steam or water directly on the radiator. Do not allow water to get on any electrical component. WA90-5 – VEAM270100 5-11