SECTION 2 SAFETY PRECAUTIONS Page 10 MAINTENANCE Ether starting fluid is flammable. Follow the precautions printed on the container. An explosion can result if sparks or flame contact ether in a container or if a container is stored in an area where the temperature exceeds 70 [°C]. Observe the following precautions: 1. Follow the correct method for starting the engine. Refer to "STARTING THE ENGINE", Section 4. 2. Do not use the ether injector when the ambient temperature is above freezing. 3. For your own personal safety, always remove the ether container when welding, grinding or using a torch on a machine. 4. Do not let ether come in contact with your skin, as it can cause local freezing.
5. Do not breathe in hazardous ether vapor. 6. Keep a fluid container out of reach of children. 7. Never puncture a fluid container or put it into fire. Dispose of an empty container properly. 8. Do not store fluid containers in the operator's compartment. Never mix gasoline or alcohol with diesel fuel. This creates an extreme fire or explosion hazard, which could result in personal injury or death. Do not use bleach, color dye or solvents on the seat belt webbing. This may cause a severe loss of tensile strength. This could cause the webbing to break resulting in personal injury. It is recommended that the seat belt be cleaned only with warm water and mild detergent. 2.5.
SHUTDOWN If parking on or near traffic lanes cannot be avoided, provide appropriate flags, barriers, flares and warning signals. Also provide advance-warning signals in the traffic lane for approaching traffic. Park the machine in a non-operating and non-traffic area. Park the machine on level ground whenever possible. If you must park on a slope, park at the right angle to the slope. Apply and lock the brake pedal. Never leave a machine unattended with the engine running. When leaving a machine unattended, slowly lower the hydraulic equipment to the ground, shift the transmission into neutral and lock the neutral lock lever, shut off the engine, apply and lock the parking brake.
Relieve any pressure in the hydraulic system by moving the controls in both directions. Turn off the electric system master switch and take the key out. Always lock up the machine when leaving it unattended, including any anti-vandalism attachments. Do not jump off a machine. When operating in bad weather and storm lightening is nearby, dismount and seek shelter away from the machine. Lightening will be attracted to the machine and can cause serious injury or death. When a machine is to be loaded onto a transport truck and trailer do so carefully. Load only when the trailer is level. The steel track shoes will slide easily on the trailer.
When the machine is properly positioned chain it securely so it can not move on the trailer. Keep away your head, body, feet, hands and fingers from a blade or ripper when they are in a raised position. TD-25H DRESSTA