POWER TAKE OFF 00-33 6. Low-Pressure Hose Loosen the hose band and remove the hose from the oil pump. 7. High-Pressure Hose Loosen the hose joint and remove the hose from the oil pump. Notice: For the high-pressure hose, the joint may not be re- moved in the oil pump fixed state according to the type of the truck and equipment. In that case, slightly loosen the joint to set the state. At the stage where the rear oil pump is removed (Item 10), remove the high-pressure hose rotating the oil pump. NPA0071E Legend 1. Oil pump 2. Bolt 3. Shift cap 3. Bolt (Cable Holder) 4. Cable Holder 5. Control Cable Notice:
Before removing the control cable, be sure to refer to Items 3 to 6 of “Removal” of the “Control Cable for Rear Dump Truck” described previously and perform work in accordance with the items. NPA0073E Legend 1. Low-pressure hose 2. High-pressure hose Notice: Because hydraulic operating fluid flows out when the hose is removed, quickly make the hose port face up- ward and protect the hose so that dust or foreign matter will not be mixed in, then fix it to the frame with a wire. NPA0072E Legend 1. Cable holder 2. PTO 3. Bolt 4. Control cable