OPERATION 3.18 CENTRAL REFILLING SYSTEM 3.18.3 RECEIVER PANEL WITH MONITOR BOX Legend for illustration Z 22469: 261 3 Service arm, hydraulically operated 4 Monitoring and control box 5 Push button for testing lamps (6, 7, 8, 9, 10 and 11). Push the button, all lamps must light up. If a lamp does not light up, corrective action must be taken. 6 Indicator lamp, fuel tank full. (H139) 7 Indicator lamp, grease container of Central lubrication System FULL. (H76) 8 Indicator lamp, grease container of Swing circle pinion Lubrication System FULL. (H78) 9 Indicator lamp, engine oil reserve tank for Front engine 2 FULL. (H142-2) 10 Indicator lamp, engine oil reserve tank for Rear engine 1 FULL.
(H142-1) 11 Indicator lamp, main hydraulic oil reservoir FULL. Recheck hydraulic oil level at the sight gauge before operating the machine. (H52) 12 Receiver panel 13 Fuel filling adapter, observe lamp (6). REMARK The fuel nozzle cut-out pressure should be adjusted to 0,38 bar. If this pressure is too low for filling the fuel tank up to the correct level, gradually increase the cut- out pressure until the pressure is sufficient for filling up to the correct level The maximum flow rate should not exceed 680 liter per minute. 14 Adapter for filling the grease container of the Central Lubrication System (CLS).
Before filling the grease con- tainer make sure the grease filter in the filling line is not obstructed. Observe lamp (7). 15 Adapter for filling the grease container of the Swing cir- cle pinion Lubrication System (SLS). Before filling the grease container make sure the grease filter in the filling line is not obstructed. Observe lamp (8). 16 (Fr.) Front engine, (Rr.) Rear engine. Oil evacuation and filling adapter connected to the engine oil pan. Monitor oil level at level gauge.