TRANSMISSION Ch 2 page 158 Use grease to fix the axial washer 80x105x1 (1) to washer (2). By means of a suitable pressure piece the washer (2) must be pressed until contact is obtained, i.e. until the snap ring has engaged into the recess of the washer. Figure 474 NOTE Both ends of the snap ring must be located in one of the four mounting holes (see arrows)! The snap ring must be engaged into both recesses of shaft and gear! Figure 475 Heat up the bearing inner ring of the taper roller bearing (approx. 120° C). Figure 476 Assemble the bearing inner ring (1) until contact. WARNING Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 477 SHOP MANUAL CAUTION