Ch 2 page 173 TRANSMISSION Assemble the bearing inner ring (1) until contact. Use safety gloves! Adjust the bearing inner ring after cooling down! Figure 532 Install, align and grease the rectangular rings 42x2.5 (1). Figure 533 NOTE Check closing and opening of the clutch by means of compressed air at the hole (see arrow). Closing and opening of the clutch must be clearly audible. Figure 534 Insert clutches ”A“ into mounting device II. See marking on the mounting device! (S) Mounting device II 850317-00077 Figure 535 SHOP MANUAL WARNING CAUTION NOTE