TRANSMISSION Ch 2 page 174 Check of the disk clearance all clutches Used snap ring (1) thickens Clutch E - 4,00 mm Clutch R - 3,00 mm Clutch B - 3,00 mm Clutch V - 3,70 mm Clutch C - 3,00 mm Clutch D - 3,00 mm Clutch A - 3,00 mm Figure 536 Position dial gauge at end plate. Preload disk package with 100 N and set indication to zero. For 8 EP 320/370 A lift end plate evenly and check required disk clearance: Clutch E - 3.90 mm – 4.70 mm. Clutch R - 3.90 mm – 4.70 mm. Clutch B - 3.90 mm – 4.70 mm. Clutch V - 3.80 mm – 4.60 mm. Clutch C - 3.90 mm – 4.70 mm. Clutch D - 3.90 mm – 4.70 mm. Clutch A - 3.90 mm – 4.70 mm.
Figure 537 For 8 EP 420/470 A lift end plate evenly and check required Disk clearance: Clutch E - 4.20 mm – 5.00 mm. Clutch R - 4.20 mm – 5.00 mm. Clutch B - 4.20 mm – 5.00 mm. Clutch V - 3.80 mm – 4.60 mm. Clutch C - 4.20 mm – 5.00 mm. Clutch D - 4.20 mm – 5.00 mm. Clutch A - 4.20 mm – 5.00 mm. NOTE If the required disk clearance is not achieved, replace the snap ring (1) as specified below: • If the disk clearance is too small, install a thinner snap ring. • If the disk clearance is too big, install a thicker snap ring. SHOP MANUAL