TRANSMISSION Ch 2 page 230 Refitting breather, Oil sight level glass, Cover plate and screw plug 1 2 1. Eye bolt M20 3 2. Breather (M10x1) Tightening torque M A = 12 Nm 3. Oil filler plug M42x2 with O-ring 38x2.5 Tightening torque M A = 145 Nm 4. Connection Power take-off O-ring 154x3 for the pump ¤ Hexagon screw 18x50 ¤ Tightening torque M A = 330 Nm 4 5. Cover plate gasket 9 8 Hexagon screw M8/8.8x18 Tightening torque M A = 23 Nm D 6. Oil sump Adhesive Thermostat MS-9360 7. Oil drain plug with magnetic insert M38x1.5 with O-ring 35x2 Tightening torque M A = 80 Nm (Loctite 557) s 8. Dipstick solution See Figure 746 7 9.
Emergency steering pump 6 5 Reassembly ¤ Insert O-ring 100x3 (1) into the annular groove of the piston and grease it. ¤ Mount emergency steering pump and fix it with hexagon screws. ¤ Wet mounting thread with Loctite™ 243 ¤ Tightening torque (M8/8.8x170) M A = 23 Nm ¤ Esure correct installation position D= Pressure port M22x1.5 S= Suction port M28x1.5 Figure 745 Refitting transmission Dipstick 1. Mount level sensor and connector to housing (1) with screw (2) and the washer (3) Tightening torque M A = 8 Nm 2. Mount housing (1) for level sensor to transmission using screw (4) washer (5) and seal washer (7). Tightening torque M A = 20 Nm Figure 746 SHOP MANUAL