TRANSMISSION Ch 2 page 244 1. Apply LOCTITE 262 to the breather (contact surface with housing). 2. Insert the breather (1) flush with the housing in the direction of the arrow. Figure 794 Installing input Installing disk for contact pattern. 1. Insert shim (1) with e. g. s = 1.0 mm into bearing hole. When dismantling use disassembled shims. Replace damaged shims by new shims with identical thickness. WARNING Figure 795 Risk of burn injuries due to contact with hot surfaces. Slight or moderate injury possible. Wear protective gloves. 2. Heat bearing hole. 3. Insert bearing outer ring (1) in the housing hole until contact is obtained.
Figure 796 WARNING Risk of burn injuries due to contact with hot surfaces. Slight or moderate injury possible. Wear protective gloves. 4. Heat bearing hole. 5. Insert bearing outer ring (1) in the housing hole until contact is obtained. Figure 797 SHOP MANUAL