Ch 2 page 247 TRANSMISSION 16. Cover several drive and coast flanks on the crown wheel with marking ink. 17. Insert differential in the housing with Extracting device K9005604, Eyebolt 940301-14681 and crane. Figure 805 18. Insert the shim determined on the crown wheel side in the bearing hole. 19. Insert bearing outer ring until contact is obtained. Figure 806 20. Screw in two units Fixingpin. 21. Install the housing with Lifting beam and crane. 22. Secure the housing with six hexagon screws. Tightening torque: 185 Nm Figure 807 SHOP MANUAL