Ch 2 page 253 TRANSMISSION Carry out the following two work steps immediately one after the other. 18. Apply PHЦNIX SPIRITUS to the outer diameter of the shaft seal. Insert shaft seal with the seal lip facing the oil chamber. 19. Insert shaft seal ring with Driver tool Figure 826 20. Press screening plate (1) onto the output flange until contact is obtained. Figure 827 21. Push output flange (2) onto output shaft. 22. Insert O‑ring (1) into the space between output flange and output shaft. Figure 828 23. Position disk and the washer(2). 24. Screw in and tighten hexagon screws (1). Tightening torque: 58 Nm Figure 829 SHOP MANUAL