Ch 2 page 89 TRANSMISSION Clutch “R” Disengage and remove both rectangular rings (1). Figure 217 Idler Pull the bearing inner ring off the shaft. (S) Grab sleeve 850317-00081 Figure 218 Disassemble snap ring Flush-mount the snap ring with a screw driver at the 4 installation openings of the washer into the annular groove of the shaft (see arrow (Figure 220)) and at the same time pull off the idler with a three-armed puller. Figure 219 Legend: 1 = Idler 2 = Shaft 3 = Axial bearing cpl. 4 = Washer 5 = Snap ring Figure 220 SHOP MANUAL