Control functions ECS00120 NOTICE The brake lever is equipped with a position adjuster. To adjust the brake lever position: 1. Loosen the locknut. 2. While lightly pushing the brake lever in di- rection (a), finger tighten the adjusting bolt to set the brake lever to the desired position. G Do not use accessories requiring more than the maximum rated capacity for the auxiliary DC jack. This may overload the circuit and cause the fuse to blow. (See page 67 for the specified amperage.) G Do not use an automotive cigarette light- er or other accessory with a plug that gets hot because the jack can be dam- aged. Maximum rated capacity:
DC 12 V, 2.5 A (30 W) ESU10560 Brake lever The snowmobile is stopped by braking the en- tire drive system. Squeeze the brake lever towards the handle- bar grip to stop the snowmobile. 1. Locknut 2. Adjusting bolt 3. Tighten the locknut securely after adjust- ing the brake lever. ESU10581 Parking brake lever When parking the snowmobile or starting the engine, apply the parking brake by moving the parking brake lever to the left. Make sure that the brake lever end does not project out over the handlebar end. This will help prevent brake lever damage when the snowmobile is placed on its side for service. To release the parking brake, move the park- ing brake lever to the right.
18 ECS00060 NOTICE 1. Parking brake lever NOTICE