Torque Values TM2362 (25JUN08) 00-0003-2 450DLC Excavator Repair 062508 PN=24 00 0003 2 Additional Metric Cap Screw Torque Values –UN–18OCT88 CAUTION: Use only metric tools on metric hardware. Other tools may not fit properly. They may slip and cause injury. T6873AA Check tightness of cap screws periodically. Torque values listed are for general use only. Do not use these values if a different torque value or tightening procedure is listed for a specific application. Shear bolts are designed to fail under predetermined –UN–18OCT88 loads. Always replace shear bolts with identical grade. Fasteners should be replaced with the same or higher grade.
If higher grade fasteners are used, these should T6873AB only be tightened to the strength of the original. Make sure fastener threads are clean and you properly start thread engagement. This will prevent them from failing when tightening. –UN–18OCT88 Tighten cap screws having lock nuts to approximately 50 percent of amount shown in chart. T6873AC Continued on next page 04T,90,M170 –19–29SEP99–1/2