a ~$4~~; Faiaix; follow these safety precautions may lead 6. GENERAL PRECAUTIONS l Any modification made without authorization from Komatsu can create hazards. UNAUTHORIZED MODIFICATION l Before making a modification, consult your Komatsu distributor. Komatsu will not be responsible for any injury or damage caused by any unauthorized modification. -I STANDING UP FROM THE SEAT 1 ALWAYS move the SAFETY LEVER to the LOCK position before standing up from the operator’s seat. If you don’t, you could unintentionally hit the control levers, resulting in sudden machine movement and the possibility of damage, injury or death.
Before leaving your machine, lower the blade to the ground, move the SAFETY LEVER to LOCK, and stop the engine. Machine posture + See “12.11 PARKING MACHINE”. AE109800 -j MOUNTING AND DISMOUNTING 1 NEVER jump on or off the machine. NEVER get on or off a moving machine. When mounting and dismounting, face the machine and use the handholds and steps. Maintain three-point contact to be sure that you do not fall from the machine. Do not hold any control levers when getting on or off the machine. Repair any damaged handhold or step, and tighten any loose bolts. Handholds and steps must be free of oil, grease and excessive dirt.
When mounting or dismounting, or when moving along the top of the track, if you hold the door handle and the door is not properly closed, the door may move and cause you to fall. Always make sure that the door is properly closed. When mounting or dismounting, use the points marked with arrows in the diagram below. AE109810 l-3