Clamp the feed pump with a vise and disassemble the plugs (30, 32), strainer (31) and gaskets (35, 36). Take off the priming pump (25), plug (16), both gaskets (18), spring (15), and check valve (14). Take off the prig (7), gasket (8), spring (6), and piston (5) on the piston side. Pull out the snap ring (20) holding the tappet (10). Disassemble the snap ring, then take off the tappet (10) and push rod (1). 3) Inspection If the check valve is damaged or scored on its seat face, replace it with a new one. Inspect the piston and tappet for damage. Replace the push rod if excessively worn, and replace together with the pump housing if required.
The inspection for wear should be performed in the same procedure as for suction pressure test described below. 4) Reassembly Reassembly operation is performed in reverse order of disassembly. All the gaskets must be replaced with new ones at reassembly. NOTE : Clean it when fuel filter cartridge is replaced. Check the item no. 30 before assembling it whether it is the fuel strainer bolt. 5) Testing (1) Suction capacity test Connect one end of a hose to the inlet side of the feed pump and immerse the 연료 토출 호스 Outlet hose other end of it into the fuel tank as illus- Feed pump trated. 연료 공급 펌프 Hold the feed pump in position about 1 m above the level of fuel in the fuel tank.
Operate the tappet at the rate of 100 rpm and check to see if fuel is drawn in and 연료 흡입 호스 Inlet hose delivered for 40 seconds or so. EQM4022I - 137 - MAINTENANCE OF MAJOR COMPONENTS F연u료el 탱ta크nk