Apply oil to the entire part of the bear- ing cap bolts, then tighten in tighten- ing sequence to specified torque. After semi-tightening both bolts even- ly, tighten them diagonally to about 15kg . m for the first stage and 25 kg . m EAMD079I for the second stage respectively, then tighten them completely to the specified torque using a torque wrench. Tighten the bearing cap in the sequence of 4-3-5-2-6-1-7. Check to see that the assembled crankshaft turns smoothly. 3.3.6. Flywheel housing Temporarily install the guide bar on the cylinder block. Apply gasket to the cylinder block.
Using the dowel pin and guide bar, install the flywheel housing and tight- en the fixing bolts in a diagonal sequence to specified torque. EAMD043I 3.3.7. Rear oil seal Apply lubricating oil to the outside of the oil seal and flywheel housing inside diameter and fit them over the crank shaft, then assemble the oil seal using an oil seal fitting jig. - 79 - REASSEMBLY Torque 30 kg.m Torque 12 kg.m