3.3.10. Timing gear case Mount gasket using dowel pin on the cylinder block. Install the timing gear case by aligning the dowel pin with the dowel pin hole on the timing gear case. EAMD082I 3.3.11. Timing gear Install the oil pump idle gear onto the No.7 bearing cap. Install a thrust washer over the camshaft and assemble the cam gear 아이들 기어 핀 Idle gear pin by aligning it with camshaft key groove. EAMD083I With the oil port on the idle gear pin facing the cylinder block, install the 아이들 기어 핀 Idle gear pin idle gear pin. EA8M3004 Install the idle gear by coinciding the marks impressed on the crank gear, Mark “2” cam gear, fuel injection pump drive 표시 "2" gear, and idle gear.
Install a thrust washer on the idle gear Fuel injection pump drive gear Idle gear 연료 분사 펌프 드라이브 기어 아이들 기어 1 Cam gear 캠 기어 2 2 2 1 1 and tighten to specified torque. Mark “1” Check and adjust the amount of back- 크랭크 기어 표시 "0" Mark “0” 표시 "1" lash between gears using a feeler EA8M3005 gauge. - 81 - REASSEMBLY Torque 3.8 kg.m End play Limit 0.13 ~ 0.27 mm 0.30 mm Torque 7.4 kg.m Backlash 0.15 ~ 0.25 mm