3.3.23. Cylinder head Install the injection nozzle fixing stud bolts and water pipe fixing stud bolts. Clean the head bolt holes on the cylin- der block with compressed air to remove foreign substances and thor- oughly clean the gasket fitting face of the cylinder block. Install head gasket, with “TOP” mark facing upward, on the cylinder block by aligning the holes with dowels. TOP EAMD101I Check the inside of combustion cham- ber for foreign substances, and care- fully mount the cylinder head assem- bly in the block by aligning the dowel pin with the dowel pin hole. Be careful not to damage the head gasket.
If the dowel pin is not in align- ment, lift the cylinder head again and then remount it. - 88 - REASSEMBLY Cylinder head gasket Asbestos core type Rubber color ; Black Semi steel type Rubber color ; Red Use bolt TY 12.9T TY 10.9T TY DL08