Operation Section (6) Front Floodlights Push down on the switch(14), to the first step, to turn the front floodlights on. (7) Engine Oil Pressure Indicator Light Indicates insufficient engine oil pressure. The light will come on when the ignition switch is turned to the ON position. The light should go off after the engine is started. If the light turns on while operating the lift truck, insufficient engine oil pressure is indicated. Park the lift truck and stop the engine. (8) Parking indicator light The light will come ON when the parking lever is applied. (14) Directional Turning Indicator Light Pull the lever to activate the right turn signal.
Push the lever to activate the left turn signal. (9) Levering light(If Equipment) Indicates tilt and lift control lever. The light comes on when lift and tild lever move forward/backward with installed solenoid valve. (10) Seat Belt Warning Light Indicates when the seat belt dose not fastened by operator. The light will come on when the ignition switch is turned to the on position. The light should go off after engine is started. (11) Seat Leaving warning Light When operator leaves seat without engine stop, hydraulic control lever cannot operate. (12) Transmission Neutral Position Light Indicates the neutral position of transmission.
(13) Engine Malfunction Indicator Lamp Engine control systems are equipped with built-in fault diagnostics. Detected system faults can be displayed by the Malfunction Indicator Lamp (MIL) as Diagnostic Fault Codes (DFC) or flash codes, and viewed in detail with the use of service tool software. When the ignition key is turned ON the MIL will perform a self-test, illuminate once and then go OFF. If a detected falut condition exists, the fault or faults will be stored in the memory of the engine control unit(ECM). Once a fault occurs the MIL will illuminate and remain ON. This signals the operator that a faults has been detected by the ECU. 51