. MAINTENANCE SERVICE PROCEDURE CHECK TRANSMISSION OIL LEVEL, ADD OIL WARNING (F). 4 - 24 The p arts and o il are at high temp erature immediately after the e ngine is stopped , and may cause burns . Wait for the temperature to go down bef ore starting the w Carr y out this procedure if the re is any sig n of oil on the transmission c ase, or if there is oil mixed with the cooling wate 1. Start the e ngine and run i t for at least 5 minutes 2. Open the cap of oil filler p ort (F), remov e dipstick (G), and wipe he oil off with a cloth. 3. Fully inse rt dipstick (G) in to filler pipe, then remove i 4. The oil lev el should be be tween the H and L marks o n dipstick G).
f the oil le vel is below the L mark, add oil t hrough oil filler port 5. I f the oil is above the H m ark, drain the excess e ngin e oil from drain plug (P), and check the oil level again f the oil le hen tight