. MAINTENANCE SERVICE PROCEDURE MAINTENANCE AND INSPECTION AND TIME TO EXECUTE THEM Inspection location Replacement interval Filter 2 years Condenser - Belt 2 years Refrigerant gas - Piping - Receiver drier 2 years REPLACE SLOW BLOW FUSE NOTICE Always turn the power OFF when replacing the slow blow fuse (turn the starting switch to the OFF position). Always replace the slow blow fuse with a fuse of the same capacity. 1. Turn the starting switch to the OFF position (A). 2. Remove the slow blow fuse box from the chassis. 3. Open covers (1), (2), and (3) of the slow blow fuse box.
Covers (2) and (3) can be removed easily by using protrusion (A) on the body as a fulcrum and levering the catch of the cover with a flat-headed screwdriver to release it. 4. Loosen screws (4) and (5), and remove. When screws (4) and (5) are removed, slow blow fuse (6) will also come off together with electric wiring (7) and (8). 5. Using screws (4) and (5), install a new slow blow fuse together with electric wiring (7) and (8) to the slow blow fuse box, then close covers (1), (2), and (3). 6. Install the slow blow fuse box to the chassis.
4 - 35 Item to check for Check before operating 6 months Clogging, dirt Carry out check - Clogging, dirt Carry out check - Looseness, damage Carry out check - Amount - Carry out chec Looseness, damage, leakage - Carry out chec - - -