. MAINTENANCE SERVICE PROCEDURE ADJUSTING then loosen the locknut of bolt (3). and the locknut of bolt (3) to hold NOTICE and the that 4 - 48 1. Tighten bolt (3) and mov 2. Tighten bolts (1) and (2 compressor (4) in positio Check each pulley for damag e, wear of the V-groove, and wear of the V-belt. In particular, be sure to bottom of the V-groove. In case any of the following oc territory to replace the belts w • The fan belt has elongated, leaving little allowance for adjustment.
• A cut or crack is found on t • Slipping or creaking sound When the new V-belt is set, re adjust it after one hour of operatio CHECK FOR LOOSE WHEEL HUB BOLTS, TIGHTEN I f wheel hub nuts (1) are lo accidents may be caused. 1. Check for loose nuts, an When checking for loos direction of tightening to Tightening torque: 825 to (84 to 2. If any stud bolt is broke wheel. 1. Check for loose nuts, an When checking for loos direction of tightening to