. OPERATION OPERATION CAB TILT OPERATION WARNING 3 - 108 To prevent se rious injury or death if the cab come s down, al ways observe t he f ollowin g strictly when tilting the cab. Precautions b efore performing cab tilt operation a flat place. Perform th e cab tilt operation on To prevent interferenc e between the cab and ma chine bod y when performing the tilt operation, set the machine facing directly to the front and secure the front and rear frame s with the articulation lock. Set the par king brake switch to t he "PARKING" position t o apply the parking brake.
Lock the d ump control lever with the dump lev er lock kno Put blocks under the ti res to pre vent the machi ne from m Do not perf orm the ca b tilt opera tion in the stro Precautions w hen performing cab ti lt operation Do not ope rate the cab tilt when the machine is Do not stan d under th e cab durin g the cab tilt o While the c ab is tilted up, fix it wi th the lock bar securely. While the c ab is tilted up, do not ride on or get While the c ab is tilted up, do not operate the ge ar shift lev er or dump contro Do not star t the engine while the cab is tilted up .
If it is nec essary to s tart the engine when carrying out inspection, check first that there i s no one under the ca Do not sub ject to the machine to any large imp act force w hile the cab is tilte d up. When lowe ring the cab by using the tilt cylinde r, do not lo wer the hydraulic pressur e at a time but lower i t gradually to adjust the lowerin g speed of the cab. The lock ba r is set on the right in side of the en gine hood. After using it, be s ure to r eturn it.