0A-28 General Information 3. Action keys (YES, NO, ENTER, EXIT) Confirm Tech2 operations, respond to screen instructions/questions, switch/move to the various menu screens. 4. Function keys (F0 - F9) Confirm menu functions displayed on the screen. Also when "F0" etc., is displayed on the menus on the screen, the keys correspond to that display. 5. Help key (?) Displays a screen explaining the Tech2 function being used. 6. Control key (PWR or SHIFT) The PWR key turns the power of the Tech2 ON/ OFF. The SHIFT key is used when adjusting the screen contrast. The LED (orange) lights up when the SHIFT key is available. At this time, the key and functions other than the selection key are locked.
The LED (green) lights up when the power is turned ON. 7. Wide stand Used as a stand. The operating angle of the stand is 0 to 180 ° . 8. Display (liquid crystal display) The liquid crystal display has a contrast adjustment function. Displays the ECM information and the various instruction screens. 9. Vehicle communication interface (VCI) module The module that enables communication between the vehicle and Tech2. 10. VCI module fastening bar Operate the bar to attach/fix, or remove the VCI. 11. DLC cable connecting connector Connector for using (connecting) the Tech2 with the vehicle. Connect the DLC cable. 12. AC adaptor connector Connector for connecting the included AC adaptor.
Enables the Tech2 to be used away from the vehicle. 13. PCMCIA card insertion opening (with cover) Open the cover to insert a PCMCIA card into the Tech2. Insert the PCMCIA card with the cover opened. Never insert/remove the PCMCIA card with the Tech2 turned ON. 14. PCMCIA card release (removal) button Used when removing the PCMCIA card from the Tech2. The PCMCIA card can be removed when the button is pressed. Never remove the PCMCIA card with the Tech2 turned ON. 15. Connector for external communication (RS-485 port) This port is for connecting to a telephone line, but is currently not used for the Tech2. Do not connect a telephone line, etc., to this port. 16.
Connector for external communication (RS-232 port) This port is for connecting the Tech2 to another computer. Parts of the Tech2 24 V adaptor 2 1 2 3 1. Signal change switch The Tech2 adaptor 2 has a selector for switching signals (the signals for each electronic control unit (ECU)). (The position of the switch is free for other than the following device) “2” : HSA 2. DLC connecting cable Connects the Tech2 adaptor 2 to the vehicle DLC (pole 16, blue). 3. Tech2 connecting cable Connects the Tech2 adaptor 2 to the Tech2. LNW7Z0SF000301