63 PERIODIC SERVICE B Replacing Transmission Oil Filter [SUCTION] B Changing Hydraulic Tank Oil To avoid personal injury: A Be sure to stop the engine before changing the oil filter. A Allow engine to cool down sufficiently, oil can be hot and can burn. To avoid personal injury: A Be sure to stop the engine before changing the oil. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1. Park the vehicle on a firm, flat and level surface. 2. Tilt the seat. 3. Remove the under guard. 4. To drain the used oil, remove the drain plug and filling plug and drain the oil completely into the oil pan. 5. After draining, reinstall the drain plug. 6. Install the under guard. 7.
Fill with new KUBOTA SUPER UDT fluid up to the upper notch on the dipstick. (See "LUBRICANTS, FUEL AND COOLANT" in "MAINTENANCE" section.) How to check: Wipe dipstick clean with a rag and screw it into filling hole. Remove dipstick again to see if the oil level is between the upper and lower notch. 8. After filling, reinstall the filling plug. 1. Park the vehicle on a flat surface, raise the cargo bed, and mount the safety support. 2. Remove the rear guard and hose guard. 3. Remove the oil filters. 4. Put a film of clean transmission oil on the rubber seal of the new filter. 5.
Quickly tighten the filter until it contacts the mounting surface, then, with a filter wrench, tighten it an additional 1 turn only. 6. After the new filter has been replaced, fill the transmission oil up to the upper notch on the dipstick. 7. After running the engine for a few minutes, stop the engine and check the oil level again, add oil to the prescribed level. 8. Make sure that the transmission fluid doesn't leak past the seal on the filters. 9. Install the rear guard, and the hose guard. (1) Transmission oil filter (Suction) (Orange color) (2) Rear guard (3) Hose guard (1) Under guard A To prevent serious damage to the transmission, use only a KUBOTA genuine filter.
Oil Capacity 14.5 L (15.3 U.S.qts.)