Industrial — 2–3. DIAGNOSTIC DATA READER (Figure 2–1)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL DEFINITIONS AND ABBREVIATIONS 800 x 600 screen resolution 256 color palette (set to small fonts) A media player program (Windows Media Player ® 7.0 is provided on the ATDT™ CD) Adobe Acrobat ® 4.0 (Provided on the ATDT™ CD) Note: PCCS, when recalibrating World Transmissions models, does not support Windows NT ® . * While ATDT™ software may operate on systems with 32 MB of Ram, a 150 MHz Pentium, and one available COM port, installation on any of these lesser configurations is not recommended and will not be supported. For further information on ATDT TM, , see Appendix N. 2–3.

DIAGNOSTIC DATA READER ( Figure 2–1) The current Diagnostic Data Reader (DDR) is the Pro-Link ® 9000 diagnostic tool which is available through Kent-Moore Heavy-Duty Division. A portable microcomputer-based receiver/transmitter/display unit, the Pro-Link ® transmits and receives data to and from the ECU, processes the data, and displays appropriate information. Use the Pro-Link ® during installation checkout and troubleshooting. There is a new Pro-Link ® cartridge needed for use with WTEC III controls. The new Multi-Protocol Cartridge (MPC) contains a programmed PCMCIA card which allows for reprogramming of GPI/GPO packages.

Reprogramming includes selection of a GPI/GPO package, enabling/disabling of wires and modification of certain data parameters. Operating instructions are supplied with each Pro-Link ® and further information is also included in Appendix N of this manual. Connect the Pro-Link ® 9000 to the diagnostic connector provided in the selector wiring harness. Tool part numbers for the Pro-Link ® are as follows: Diagnostic Kit J 38538D + J 38500–313 (PROM Update) = J 38538E MPC J 38500–1500C PCMCIA (Diagnostic And Reprogramming) J 38500–1700B PCMCIA (Diagnostic Only) J 38500–1800A NOTE:

The new MPC is usable with WTEC II controls but the old WTEC II reprogramming cartridge will not display the WTEC III new information. The new MPC must be used to reprogram WTEC III systems. Figure 2–1. Pro-Link ® 9000 Diagnostic Tool V04842 Copyright © 1999 General Motors Corp.