EXPLANATION OF COMPONENTS OPERATION ELECTRIC POWER TAKE-OUT ADAPTER NOTICE G Do not use as a power supply for 12V equipment. This will cause failure of the equipment. G When using as a power supply pickup, do not install equipment which exceeds 120W (24V x 5A). (Machine equipped with cab) It is possible to remove the cigarette lighter and use the socket as a power supply. Capacity of cigarette lighter: 120W (24V x 5A) (Machine not equipment with cab) 1. Open battery cover(1) on the left side of the machine. 2. Pull out the electric power take-out connector for the cab.
(A single-pole connector CN25(2) or a single-pole con- nector CN24(3) for an optional device can be used.) Connector CN25 and CN26 are secured to the main har- ness with a band. When using CN25, remove it. After using it, secure it with the band again. Connector CN24 is secured to the main harness with a tape. Capacity of each connector: G CN25(2): 120W(24V x 5A) G CN24(3): 480W(24V x 20A) REMARK G Ground the negative wire to the body work or ROPS. Do not ground it to the rubber mounted engine or valves.This will cause failures. G If the wire is grounded to a point where there is still paint, the electricity will not flow smoothly, so remove the paint. 3-24