Safety Precautions General recommended by the manufacturer. When it has been used, have it refilled at the earliest opportunity. Make sure that you always have a first aid kit with you. Replenish the contents as soon as possible after use. When winter driving conditions are expected, ensure that your vehicle is prepared in accordance with the recom- mendations in “Preventive Maintenance Before the Winter Season” on page 88 . When severe winter driving conditions are anticipated, ensure that your vehi- cle is fitted with winter tires or that you have snow equipment, as allowed by state law.
Winter Driving Conditions First Aid Kit The load must always be properly secured so that it cannot move while the vehicle is in motion, even during an emergency stop. Side walls, partitions, headboards, etc., are not designed to withstand high forces. Loads must not project more than is permitted by local or national regulations. The stability of the vehicle may be impaired by the load and an increased turning circle may be required. Ensure that you always have a fire extinguisher with you. It should be well secured within hand’s reach of the driver and easily accessible for rescue workers and others providing assis- tance.
Have the fire extinguisher checked for operational readiness as Fire Extinguisher Vehicle Load Disconnect all Electronic Control Module (ECM) connectors (on electronic engines). Do not use the ECM or engine ground stud for the ground of the welding probe. Ensure that the ground connection for the welder is as close to the weld point as possible. This ensures maximum weld current and minimum risk to damage of electrical components on the vehi- cle. Before welding anywhere on the vehi- cle, detach the ABS Electronic Control Unit (ECU) connector and all other electronic control units. All Anti–Lock Braking Systems (ABS)