. OPERATION EXPLANATION OF COMPONENTS the pilot lamp on the machine monitor light up. 3 - 33 POWER MODE SELECTOR SWIT CH tch the power mode. This makes it lly in a way suited to the operating This switch (7) is used to swi possible to travel economica conditions. If portion (a) of the switch is p ressed, high-power mode pilot lamp (P) lights up and the system i s switched to the high-power mode. If portion (b) of the switch is pr essed, economy mode pilot lamp (E) lights up and the system is sw itched to the economy mode. al operations) g conditions ns on flat ground) (a): High power mode (gener Normal standard operatin (b):
Economy mode (operatio Work with emphasis on fu ground where the maxim el consumption, such as work on flat um power is not needed When working at night, the sy mbol inside the switch lights up regardless of the selected EMERGENCY STEERING SWITCH ate the emergency steering pump. This switch (8) is used to actu When the switch is pressed, the emergency pump is actuated to e steering. make it possible to operate th When the switch is ON, the p ilot lamp (red) inside the switch and The emergency steering pum p can be used for a maximum of 90 seconds.
When the emergency steering is being used, keep the travel speed to a maximum of 5 km/h (3.1 The emergency steering is ac tuated automatically in the following When the steering hydraul When the engine has stop When the emergency steerin g is actuated, stop the machine promptly and perform insp If the starting switch is at the O N position and the parking brake switch is at the TRAVEL p osition when the machine is stopped, the automatic em PARKING position. ergency steering is actuated after 1 second, so set the parking brake switch to the SHIFT HOLD SWITCH earshift limiter.
This switch (9) actuates the g Activating the shift hold functi on will restrict the automatic shifting of the transmission to gear sp eeds below the gearshift lever gear shifting. The shift hold function can be canceled by [1] moving the gearshift lever or [2] activating the shift hold switch located on the gearshift lever. The shift hold pilot lamp locat ed on the machine instrument panel will indicated the status of the shift hold function. or down a range, pre-select the Before starting either up transmission gear and mainta in a machine travel speed which will give you full control under all the anticipated conditions.