3. Operation 3.3.2 How to Start the Engine If the cooli ng fresh water runs out too often, or only the cooling fresh water in the fresh water tank drops without any change in the water level of the subtank, there may be some leakage of water or air . In such cases, consult your Yanmar dealer or distributor with - (1) Start the engine according to the following procedures : Electric Operation 1 . Open the Kingston cock. 2. Open the fuel tank cock. 3. Set the remote control lever in NEUTRAL. out delay . Note: The water rises in the subtank during engine operation. This is not abnormal.
After stopping the engine, the cooling water cools down and the extra water in the subtank returns to the fresh water tank. Safety equipment (optional) makes it impossible to start the engine in any other position than NEUTRAL. (6) Checking the Remote Control Handle Be sure to check that the remote control handle lever moves smoothly before use. If it is hard to operate, lubricate the joints of the remote control cable and also the lever 4. Turn on the battery switch. bearings. If the lever comes out or there is play in the lever, adjust the remote control cable. (See 4.3.4 (3)) 5. Insert the key into the key sw itch and turn the key to ON.
If the alarm buzzer sounds and alarm lamps come on, the alarm devices are normal. Note: The cooling water temp. warning (7) Checking the Alarm Devices Electri c lamp does not come on. (See 2.5.1. {3)) 6. Push the start button to start the engine. Release the start button when the engine has started. The alarm buzzer should stop and the alarm lamps go out. Operation When operating the key switch, check that the alarm devices work normally. (See 2.5.1 (3 )) (8) Preparing Fuel, Lube Oil, and Cooling Fresh Water in Reserve Prepare sufficient fuel for the day's operation. Always store lube oil and cooling fresh water in reserve (for at least one refill) onboard, to be ready for emer- gencies.
(!) OFF po Si ti On ~ ,® JF--.., , on I ® ON pos itiOn I ' 27