Engine Disassembly (00-01) Exhaust Manifold - Removal N14 Page 0-13 Exhaust Manifold - Removal NOTE: Two dowels are used in each cylinder head to align the exhaust manifold assembly. Remove two capscrews, and install two guide studs. Warning: Because this assembly weighs more than 23 kg [50 lbs], two people or a hoist will be required to lift the exhaust manifold assembly to avoid personal injury. Remove the remaining ten capscrews, the exhaust man- ifold assembly, and the manifold gaskets. Starting Motor - Removal Warning: Because this part weighs more than 23 kg [50 lbs], two people or a hoist will be required to lift the starting motor to avoid personal injury.
Remove the three starting motor capscrews, the starting motor, and the spacer (if used). Fan and Fan Spacer - Removal Caution: A fan hub spacer can be behind the fan. It will drop as the fan is removed. Make sure to remove the fan and the fan hub spacer together. Remove the six capscrews and the fan. NOTE: Do not discard the fan spacers. The spacers provide the thickness needed to install the fan in the correct position. Alternator Belts - Removal Loosen the alternator to alternator support nut and cap- screw. Loosen the adjusting link capscrew and tensioning bolt, if applicable. Push the alternator toward the engine to release tension on the alternator belt, and remove the belt(s).