CELECT™Actuator Harness - Removal Engine Disassembly (00-01) N14 Page 0-26 Disconnect the Deutsch three pin connector that contains the vehicle key switch, fan clutch, and engine brake con- trol wires from the three pin connector which is wired directly into the Deutsch nine pin connector on the sensor harness. Remove the actuator harness amp connector from the electronic control module (ECM). Disconnect the actuator harness from each of the pass through connectors along the side of the rocker box hous- ing. Cut and remove the plastic wire ties that hold the actuator harness to each of the pass through connectors. Remove the clamp capscrew on the rear of No. 3 rocker housing.
Remove the actuator harness from the engine.