CAB AND FRAME 2-41 Removal 1. Rear door trim pad Sealant: CEMEDINE 366DX or equivalent Refer to “Rear Door Trim Pad” in Interior & Ex- terior Trim Section. 2. Water-proof sheet Peel off it carefully with a cutter or knife. Take care not to damage it when peeling it off. 3. Bottom bracket Remove the 4 screws. 4. Rear door glass plug 5. Rear door glass Lower the glass to a position of working holes where the mounting screws can be seen, re- move the 2 screws and pull out them through the working holes in the bottom of door. 6. Window regulator Remove the 5 mounting screws (1) and pull out them through the working holes. 7. Glass run Pull out the glass run from the channel. 8.
Glass run rear channel Remove the mounting screw (2) and pull it out. N2A0075E Installation For installation, reverse the removal procedure taking the following points into consideration. 1. Align the notch (a) of the glass run lip (4) with the door outer waist line (A). Align the glass run slit (b) with the door (B) and fit the glass run between A and B. Next, align the notch (c) of the glass run lip with the door outer waist line (C) and fit the glass run between B and C. Fit the glass run in the chan- nel (5) within the panel with the lip (1) toward the outside of the vehicle. Caution: When reusing the glass run, apply the sealant to the range shown in the figure.