11 WEBM1000 Safety Section (D6T LGP (OEM)) Safety Messages Rotating Shaft (6) Do Not Weld on the FOPS (7) This safety message (6) is located on top of the guard which is covering the drive shaft for the PTO pump. The film is visible by removing the floorplate of the cab. Safety message (7) is positioned on the right side of the cab roof. m WARNING m WARNING Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification.
Consult your Cat dealer to determine this structure's limitations without voiding its certification. Rotatins shaft pinch hazard. The shaft under this cover is rotating anytime the engine is running. Contact with a rotating shaft could cause injury or death. Keep hands away. This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification plate. A typical example of the certification plate is shown above. Refer to Operation and Maintenance Manual, “Guards (Operator Protection)” for more information.