24 Safety Section (D6T LGP (OEM)) WEBM1000 Fire Safety Be familiar with the operation of the fire extinguisher. Inspect the fire extinguisher and service the fire extinguisher regularly. Follow the recommendations on the instruction plate. 3. Squeeze the handle and release the extinguishing agent. 4. Sweep the extinguisher from side to side across the base of the fire until the fire is out. Consider installation of an aftermarket Fire Suppression System, if the application and working conditions warrant the installation. Remember, if you are unable to do anything else, shut off the machine before exiting. By shutting off the machine, fuels will not continue to be pumped into the fire.
Fire Safety Note: Locate secondary exits and how to use the secondary exits before you operate the machine. If the fire grows out of control, be aware of the following risks: Note: Locate fire extinguishers and how to use a fire extinguisher before you operate the machine. Tires on wheeled machines pose a risk of explosion as tires burn. Hot shrapnel and debris can be thrown great distances in an explosion. If you find that you are involved in a machine fire, your safety and that of others on site is the top priority. The following actions should only be performed if the actions do not present a danger or risk to you and any nearby people.
At all times you should assess the risk of personal injury and move away to a safe distance as soon as you feel unsafe. Tanks, accumulators, hoses, and fittings can rupture in a fire, spraying fuels and shrapnel over a large area. Remember that nearly all of the fluids on the machine are flammable, including coolant and oils. Additionally, plastics, rubbers, fabrics, and resins in fiberglass panels are also flammable. Move the machine away from nearby combustible material such as fuel/oil stations, structures, trash, mulch and timber. Fire Extinguisher Location Lower any implements and turn off the engine as soon as possible.
If you leave the engine running, the engine will continue to feed a fire. The fire will be fed from any damaged hoses that are attached to the engine or pumps. Make sure that a fire extinguisher is available. Be familiar with the operation of the fire extinguisher. Inspect the fire extinguisher and service the fire extinguisher. Obey the recommendations on the instruction plate. If possible, turn the battery disconnect switch to the OFF position. Disconnecting the battery will remove the ignition source in the event of an electrical short. Disconnecting the battery will eliminate a second ignition source if electrical wiring is damaged by the fire, resulting in a short circuit.
Mount the fire extinguisher in the accepted location per local regulations. If your machine is equipped with a ROPS structure, strap the mounting plate to the ROPS in order to mount the fire extinguisher. If the weight of the fire extinguisher exceeds 4.5 kg (10 lb), mount the fire extinguisher near the bottom of the ROPS. Do not mount the fire extinguisher at the upper one-third area of the ROPS. Notify emergency personnel of the fire and your location. If your machine is equipped with a fire suppression system, follow the manufacturers procedure for activating the system. Do not weld the ROPS structure in order to install the fire extinguisher.
Also, do not drill holes in the ROPS structure in order to mount the fire extinguisher on the ROPS. Note: Fire suppression systems need to be regularly inspected by qualified personnel. You must be trained to operate the fire suppression system. Consult your Cat dealer for the proper procedure for mounting the fire extinguisher. Use the on-board fire extinguisher and use the following procedure: Track Information 1. Pull the pin. Track adjusting systems use either grease or oil under high pressure to keep the track under tension. 2. Aim the extinguisher or nozzle at the base of the fire.