. MAINTENANCE SERVICE PROCEDURE EVERY 500 HOURS SERVICE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING hose in general yourself, and drain the excessive metal (7 ± 1 kgm, 50.6 ± 7.2 lbft) 4 - 63 Maintenance for e very 250 hours service shou ld be carried out at t Immediately after th e engine is stopped, the oil and p arts are at high temperature, so there is danger of suffering burns during the operation. Wait for t he temperature to go down befo re starting the operatio Refill capacity: Prepare a filter 1. Remove drain tool. 2. Set a containe r in position to catch the oil, th valve (2) slow ly to avoid getting oil on you oil.
Be carefu deform the st l not to loosen drain valve (2) opper pin inside the valve. 3. Check the d rained oil, and if there ar particles or fo reign material, contact your K 4. Remove the d rain hose, then tighten drain plug (1). Tightening tor Drain plug (1), drain valve (2): 68.6 ± 9.8N Using the filte r wrench, turn 3 full-flow filter left to remove When doing th out this opera In particular, i tion from immediately under f this operation is carried ou stopping the e ngine, a large amount of oil w for 10 minutes before starting the operatio 5. Clean the filte r holder, fill the new filter car coat the seal and thread of the filter cartri ase) and install. thinly with gre 6.
When installin g the filter cartridge, tighten until the packing fac e is in contact with the fi lter holder, then tighten a further 3/4 - 1 turn. ecified amount of engine oil from oil filler (F). e for a short time at idle, then check the oil if it is filled up to a specified level. For details, see LEVEL IN ENGINE OIL PAN, ADD OIL (PAGE 3-71)". 7. Pour in the sp ecified amount of engine oil 8. Run the engin e for a short time at idle, th "CHECK OIL LEVEL IN ENGINE OIL PAN , ADD OIL (PAGE 3