. MAINTENANCE SERVICE PROCEDURE REPLACE TRANSMISSION VALVE OIL FILTER ELEMENT WARNING install it. 4 - 68 Immediately after the engine is stopped, the oil and pa rts are at h igh t emperature, so t here is danger of suffering burns during the operation. Wait for th e temperature to g o down befor e starting t he o peration. 1. Set the contain er to catch the o il under the filter case 2. Remove drain plug (1) at the bot tom of the fi lter case, drai n the oil, then tighte n the plug again. 3. Loosen hexag (2). 4. 5. Remove the el Replace the fil ement and clean ter gasket and O the inside o -ring with n f the cas ew parts. gasket and O-r ing thinly with cle an engine o il before i nstalling.
6. Assemble the new element, the and Tightening torque for drain: 49 t o 58.8 Nm (5 t o 6 kgm, 36 .2 to 43.4 lbft) Tightening torque for case: 58.8 to 78.5 Nm (6 t o 8 kgm, 43. 4 to 57.9 lbft) 7. Run the engine for a short time at idling, the n stop the engine, and chec k that the oil is u p to the specified level. For details, se e "CHECK OIL L EVEL IN TR ANSMISSIO N CASE, ADD OIL (PAGE 3- 72)". Run the engin e at high idling, a nd when the oil is warmed up, i f the Maintenance cautio n lamp flashes, replace the element im