. ATTACHMENTS, OPTIONS HANDLING TACHOGRAPH (TCO20-90W) REPLACING CHART PAPER CAUTION your finger by mistake. 1. Open up the tank cover. 2. Turn crimped ring (1) to the left, then move it up to remove it. 3. Always use a ballpoint pen to write the employee code, machine code, date, etc. on the new chart paper. 4. Insert the outside portion of the chart paper under cutter (2). Align with chart paper mount (3) of the tachograph and install the chart paper. 5. Turn the chart paper and align the present time position on the time scale on the chart paper with the time set mark (A) (red) on the tachograph. 6.
Set projecting portion (4) of the crimped ring at the bottom, and align with the groove of chart paper mount (3). Pressed crimped ring (1) down with your finger and turn it to the right to install it. 7. Close the cover. 6 - 7 When replacing the chart paper, do not touch the edge of the cutter. There is a protective cover, but t here is still danger o f cutting Always use Komatsu genuine c hart paper. If any other chart paper is used, it may cause failure of the tachograph. When adjusting the time on the chart paper between 22:40 and 24:00, always set the c utter at the bottom of the first sheet of chart paper. If it is set wrongly, the speed indicator will catch and cause f ailure.
Always start with the top sheet when using the chart paper. Do not cut the connecting t ape to separate th e chart paper and use one sheet at a ti me. This will cause the paper to catch and this will res ult in failure of the clock. Always remove and install the crimped ring by hand. Always use Komatsu genuine cha rt paper (YZ762928-260). Adjust the time before replacing th e chart paper. If the time is adjusted after the chart pap er is set in positio n, there will be a difference between the co rrect time and the set time for the chart paper. Be careful not to bend the chart pa per, damage the surface, or get water on the paper. It will become impossibl e to obtain a correct record.