. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) NOTICE "WHEN ERROR CODE F-09 IS DISPLAYED partly inaccurate. 6 - 46 If the operation is not carri ed out properly, the payload will not be me asured correctly, so t he payload meter dat a or extern al lamp display will not be correct .
When the machine is unloaded, when it is stopped for loadin g, or when i t is stop ped when l oaded, always place the gear shift In the following cases (1 ) to (4), the condition of the dump tru ck as seen by the p ayload meter will be differen t from the actual condition of t (1)When a new controll er has been installed has been replaced tery has been replaced f the following conditions should occur lamps give the estimate display although no loading is taking place.
(2)When the controller (3)When the built-in bat (4)In addition, if either o f the following conditions should occ The external display lamps give the estimate display alth ough no loading is t aking plac The display gives th e time display when loading even if m ore than 50% of th e maximum payloa d is loade d and the machine starts t o travel. (The distance display is not g iven when travelin g 0 to 160 m. (0 to 524 ft 11 in)) In the case of (1), carry out calibration. For details, see "CAR RYING OUT CALI BRATION (PAGE In the case of (2), carry o ut calibration. For details, see "OPER ATION WHEN ERR OR CODE F.CAL IS DISPLAYED OR CONTROLLER HA S BEEN REPLACED (PAGE 6-85)".
In the case of (3), c arry out calibration. For details, s (PROCEDURE FOR R EPLACING BATTERY) (PAGE 6-82) In the case of (4), carry out calibration. For details, see "CAR RYING OUT CALI BRATION (PAGE recognize the empty (stopped) condi tion. The cycle dat a recorded when d umping m ay be After starting dumpi ng (operating the dump lever from FL OAT to RAISE), d o not turn t he pow er OFF within 5 5 seconds after compl eting the dumping (operating the dum p lever from LOW ER to FLOAT). Also, with operations other than dumping, do not turn the power OFF within 5 seconds a fter ope rating the dump lever to FLOAT from any position other than FLOAT.
If the starting switch has been left at the ON position (powe r ON) for a long peri od without starting the engin e, first turn the starting swit If the engine is starte was at the ON positi the "Stopped,Loade ch to the OFF position, then start the engine. d without turning the starting switch fir st to the OFF positi on, the tim e that th e starting switch on without starting the engine will also be calculated as p art of the " Stopped,Empty" ti me or d" time.