. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER II (CARD TYPE) meter if this is not set, but when cannot be carried out if the machine ID 6 - 58 OPERATOR CHECK By using the operator check mode, it is possible t o forcibly disp lay, set, or corre ct the fo llowing (a) Memory card dump The data stored in the payload meter is written en bloc to th e memory card i nstalled in the payload m REMARK This function only work s when switch "5" (memory card switch) o n the left side fa ce of the controller is set to "used." (b) Data all clear all the cycle data, engine ON/OFF data, and problem and warning data.
This forcibly erases The data for total pa payload and overal all the cycle data, engine ON/OFF data, and problem a nd warni ng dat yload and overall number o f cycles are no t cleared. For d etails, se e "Method of cle aring total l number of cycles (PAGE 6-57)". REMARK Before clearing the dat a, download the necessary data to a pers onal computer o r carry o ut (a) Memory ca rd dump.
(c) Display of existing problems/warnings/restore status, status of input signals This distinguishes b occurred in the pas It also partially disp etween problems and warnings that are n ow occurring an d proble ms and warnings that have t and have been restored t o normal, and automatically di splays t he erro r code. ter. lays the condition of the signals from the sensors that ar e input to the p ayload me (d) Machine ID setting This is used when i Available range for nputting, correcting, or setting the dump setting: 0 - 200 REMARK There is no particular communications with t he personal computer, communications D set in the personal computer.
same as the machine I ng cable is not the (e) Open ID setting This is used when i Available range for There is no particul [Example of use of nputting, correcting, or setting the desire Number to indicate loc Operator ID number ar effect on the function of the payload m eter if this is no (f) Speed limit setting If there is a speed li meter if the dump tru limit. Available range for If the speed limit wa mit on the road that the dump truck uses , it is possible to display a warning on th e payload ck exceeds that speed. Th is function is u sed when inputt ing, correcting, or setting t he speed setting: 10 - 99 [km/h] rning is not needed, set it to 99. rning is not needed, set it t