. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN TRANSMISSION CASE AND TRANSMISSION OIL FILTER CARTRIDGE, CLEAN STRAINER WARNING engine is stopped, and may cause burns. Wait for the 4 - 54 temperature to go down b When removing the oil fill er cap, turn it slowly to release the internal Refill capacity: 54 liters Prepare a filter wrench 1. Set a container to c atch the oil under drain plug (P), then and drain the oil. pouring out suddenly, loosen drain plug remove drain plug (P) To prevent the oil from (P) and remove it gra dually. nstall drain plug (P). 6 ± 9.8 Nm (7.0 ± 1.0 kgm, 50.6 ± 7.2 ) ch the oil under the transmission filter. 2. After draining the oil, i Tightening torque: 68.
lbft Tightening torque: 68. 3. Set a container to cat ch the oil under the transmissio n filter. 4. Remove drain plug (1 ) of the transmission filter, drain the oil, again. then tighten the plug 5. Using a filter wrench, t urn filter cartridge (2) to t he left to remove it. 6. Clean in the filter holde new filter cartridge wit r, coat the seal surface h engine oil, then instal and thre l it. ad of the 7. When the seal surface comes into contact wit h the filte r holder, tighten a further 2/5 tu rns with the filter wrench. 8. Remove 4 bolts (3), m ove tube (4), then remove strai ner (5) . 9. Remove any dirt stuc k to strainer (5), then wash it in clean 10. diesel fuel or flushing oil.
If strainer (5) is damaged, r eplace it with a new part. Install strainer (5) in th e case. Replace the O-ring of tube (4) with a new part, then install tube (4).