. MAINTENANCE SERVICE PROCEDURE LUBRICATING (1) Center hinge pin (2 places) CHECK OF ENGINE AIR INTAKE PIPING CLAMPS FOR LOOSENESS 4. Bring the packing surface into contact with the seal surface of the filter holder, then tighten it further approx. 2/3 turn. 5. Open a valve (1) of the corrosion resistor at two points. 4 - 56 1. Using a grease pu mp, pump i n grease throu gh the grease f ittings marked by the arr 2. After gr easing, wi pe off any o ld grease that w as pushed ou (2) Drive sh aft center support (1 p lace) Please ask your Kom atsu distributor to check th e tightening of the clamps between the air cleaner - turbocharge - aftercoole r - engine.
REPLACE CORROSION RESISTOR CARTRIDGE 1. 2. 3. Close a Using a Apply e install it valve (1) filter wren ngine oil to to the filte