(10) Position spool and sleeve assembly so that splined end of spool enters 14 hole end of housing first. While inserting spool and sleeve assembly into housing, make sure parts do not tilt out of position. Push assembly gently into place with slight rotating action. Bring spool assembly entirely within housing bore until parts are flush at 14 hole end of housing. With spool assembly in this flush position, check for free rotation within housing by turning assembly with fingertip force at splined end. H940AC5SE18 (11) Install 72.6 mm (2.86") ID O-ring in housing. Install anti-cavitation valves and manual steering check valve (if used) in holes.
After installing balls, inspect holes to make sure they are properly seated. (12) Roll Pin (2) 40,00 mm [1.575 in.] L * Anti-cavitation valves for cylinder ports See page 4 for other configurations. Ball (2) 4,762 mm [.1875 in.] OD Roll Pin (1) 34,92 mm [1.375 in.] L Manual Steering Check Valve Ball 6,35 mm [.250 in.] OD O-ring H940AC5SE19 5-30