Timing reference data Timing reference data Align star valleys (reference A) with marked drive 1 and drive 2 (reference B). Valleys must align with pin. Note parallel relationship of reference lines A, B, C, and D in figure. Align bolt holes without disengaging gerotor from drive. Meter (Gerotor) Star Valley Gerotor — Seal Groove this Side A Spacer Plate — Seal Groove this Side O-ring O-ring B Drive (Marked) C Install spacer plate. Align bolt holes in spacer plate with tapped holes in housing. (13) D (14) Lubricate and install 72.6 mm (2.86 in) ID seal in spacer plate. Pin Port Face (15) Install gerotor (meter) seal groove up, note position of star valleys in relation to marked drive.
H940AC5SE20 (16) Lubricate and install 72,6 mm [2.86 in.] ID seal in gerotor ring. (17) Lubricate and install 72,6 mm [2.86 in.] ID seal in gerotor. (18) Install end cap on gerotor, aligning holes. Check to insure thatspool and sleeve are flush orslightly below 14 hole surface of housing. Clean upper surfaceof housing by wiping with palmof clean hand. Clean each ofthe flat surfaces of meter sec-tion parts in a similar way justbefore reassembly. Do not usecloth or paper to clean surfaces. 5-31 zSGjSGoGo jSGl z n H940AC5SE22