3 i5601E Digital Display Factory Settings Check, Load Settings Upon entry into the Factory Settings Menu the software will get data from the Network Engine Interface and Control Heads. If necessary, the software will try up to 3 times to connect and retrieve data from the units. One of the following responses will be displayed for each unit: Engine Display This allows the display to be changed to match the engine application. The choices are: Single, Port, Starboard, Center, and None. Note: The default is based on the part number of the unit. The default monitor command will reset to the factory assigned selection determined by the part number. © 2011 Yanmar Marine International • Rev.
2.0 Yanmar Electronic Control Systems Technical Manual 3:41 Engine Interface Processing Transfer OK Transfer Failed, Is ignition on? Control Head Processing Transfer OK Transfer Failed, Connection Problem?