11. EXPLANATION OF COMPONENTS 2. FUEL GAUGE This gauge indicates the amount of fuel in the fuel tank. F indicates that the tank is full. E indicates that there is less than 14 liters of fuel remaining in the tank, so add fuel. After each operation, be sure to fill up the fuel tank. 0 63 E F 4 3. SERVICE METER This meter shows the total operation hours of the ma- chine. The service meter advances while the engine is running - even if the machine is not traveling. Set the periodic maintenance intervals using this display. While the engine is running, operation display 0 at the top inside of the meter will rotate to show that the meter is ad- vancing.
Meter @ will advance by 1 for each hour of operation regard- less of the engine speed. 4. CHARGE LAMP This lamp indicates malfunction of the alternator. When the starting switch is turned ON, it will light up, but it should go out when the engine speed rises. If the lamp lights up during operation, stop the engine and check the V-belt tension. If any abnormality is found, see “16. TROUBLESHOOTING”. + 1 5. ENGINE OIL PRESSURE WARNING LAMP This lamp warns that the engine lubricating oil pressure has dropped. When the starting switch is light up. When the lamp goes off after the engine pressure is normal. When the lamp lights up during operation, lower.
turned ON, it will is started, the oil the oil pressure is Immediately stop the engine and look for the cause. For de- tails, see “16. TROUBLESHOOTING”. 6. AIR CLEANER CLOGGED WARNING LAMP This lamp warns that the air cleaner element is clogged. When the lamp is off during operation, the air cleaner is normal. When the lamp lights up, immediately clean the element. After cleaning it, confirm that the lamp is off. 7. HEATER SIGNAL This indicates the electrical intake air heater is red-heated. When holding the starting switch key at the HEAT position, this signal glows red after 20 - 30 seconds. When releasing the key, the key will return to the OFF posi- tion and the signal will go off. 2-5